彩钢板消防规范

天物彩板生产加工配送彩板一站式服务——更多山东防火彩钢房安装公司_彩钢大型厂房的安装过程请拨打网站上方电话咨询

彩钢板房消防规程

一、各级各部门要在各级市县建设部门、公安消防部门、质量技术监督部门相互配合，加强协调配合。建设主管部门和公安消防部门要加强对施工现场彩钢板结构施工用房使用的监督管理，发现问题及时向质量技术监督部门报告。质量技术监督部门参照消防法规，加强对生产流通领域彩钢板房的监督，避免选用彩钢板保温材料中的易燃、可燃材料。
彩钢板
二。就消防达成共识。全社会对消防安全已达成共识。如质量不合格，不宜使用彩钢板房，请及时向有关部门报告。目前，消防安全已成为公共安全的重要组成部分，越来越受到社会各界的重视。每个人都应该采取行动消除火灾隐患。
彩钢房防火措施到位。彩钢临时用房通常体积大，人员多，疏散非常重要。如果教学楼层多，很难及时疏散人员。因此，最高允许楼层高度不得超过两层。为了防止彩钢外墙和屋面板成为火灾蔓延的方式。材料采用不燃材料，同时室内设置消火栓系统。消防部门提醒：彩钢板最好用石棉板和耐火棉作填料，只有达到甲级耐火极限时才能满足施工现场的消防安全条件。在使用过程中，部分热源和火源不得靠近彩钢板，并保持一定距离。在彩钢板房内设置厨房时，应设置保温层，墙面应设置防火岩棉保温层。电线电缆不得穿过彩钢板。需要通过时，应加防护套。插座和开关箱应由金属镀锌箱制成，表面安装。室内外均应配备简单的消防设备，有条件时应设置火灾报警器，方便人员迅速疏散。彩钢板房之间应保持至少6米的安全距离。
彩钢板房防火方法
消防专家指出，彩钢板房防火应注意以下几个方面：
首先，彩钢板的芯材应采用耐火性能好的岩棉，芯材不得采用聚苯乙烯和聚氨酯。板房完工后，外部可见部位不得有芯材外露。
其次，在使用过程中，部分热源和火源不得靠近钢板，并保持一定距离。
第三，电线电缆最好不要与芯材交叉。如需交叉，应加防护套。插座、开关箱采用金属镀锌箱，明装方式。最后，消防设备应完好有效，人员操作熟练。如有可能，应安装火灾报警器，以方便人员迅速疏散。

Fire control regulations for color steel plate room

I. departments at all levels shall cooperate with each other in the construction departments of cities and counties at all levels, public security fire departments and quality and technical supervision departments to strengthen coordination and cooperation. The competent construction department and the public security fire department shall strengthen the supervision and management of the use of the color steel plate structure construction room on the construction site, and timely report the problems found to the quality and technical supervision department. The quality and technical supervision department shall strengthen the supervision of color steel plate house in the production and circulation field by referring to the fire laws and regulations, so as to avoid the flammable or combustible materials in the selected color steel plate thermal insulation materials.
Color steel plate
II. Reach a consensus on fire control. The whole society has reached a consensus on fire control safety. If the quality is not qualified and it is not suitable to use color steel plate houses, please report to the relevant departments in time. At present, fire safety has become an important part of public safety, and has been paid more and more attention by all walks of life. Everyone should take action to put an end to the hidden danger of fire.
he fire prevention measures for color steel houses are in place. The temporary color steel houses usually have large volume and many people, so evacuation is very important. If there are many teaching floors, it is difficult to evacuate people in time. Therefore, the maximum allowable floor height should not exceed two floors. In order to prevent the color steel exterior walls and roof panels from becoming the way of fire spread. The materials shall be non combustible; meanwhile, the fire hydrant system shall be set indoors. The fire department reminds: the color steel plate is best made of asbestos plate and fire-resistant cotton as fillers, which can meet the fire safety conditions of the construction site only when the fire-resistant limit of class A is reached. In the use process, some heat sources and fire sources shall not be close to the color steel plate, and a certain distance shall be kept. If the kitchen is to be set up in the color steel plate room, a thermal insulation layer is required, and the wall surface shall be equipped with a fireproof rock wool thermal insulation layer. Wires and cables shall not pass through the color steel plate. If they need to pass through, they shall be provided with protective sleeves. Sockets and switch boxes shall be made of metal galvanized boxes and surface mounted. Simple fire-fighting equipment shall be equipped indoors and outdoors, and fire alarm shall be installed if conditions permit, so as to facilitate rapid evacuation of personnel. A safe distance of at least 6 meters shall be kept between color steel plank houses.
Fire prevention method of color steel plate room
Fire experts pointed out that the following aspects should be paid attention to in how to prevent fire in color steel plate houses:
First of all, rock wool with good fire resistance shall be used as core material for color steel plate, and polystyrene and polyurethane shall not be used as core material. After the completion of the plank house, no core materials shall be exposed at the external visible parts.
Secondly, in the process of use, some heat sources and fire sources shall not be close to the steel plate, and a certain distance shall be kept.
Third, it is better not to cross wires and cables from the core material. If it is necessary to cross, a protective sleeve shall be added. The socket and switch box shall adopt the metal galvanized box and the open installation method. Finally, the fire-fighting equipment should be in good condition and effective, and the personnel can operate skillfully. If possible, the fire alarm should be installed to facilitate the rapid evacuation of personnel.