广西彩钢板分条剪板开料加工前要做哪些检查？

1彩涂板纵切剪板切割加工作业前，应注意穿戴劳动防护用品，包括工作服、安全帽及相关工作鞋。注意检查设备上是否有杂物，如有应清理干净。纵剪加工设备运行时，其转动部分不能放置任何物品。

2设备在 彩涂板纵切切割加工前使用时，周围不能存放易燃易爆物品，这其实是做好防火措施；下一步要检查油箱油位是否正常，油质是否变质。应避免在实际使用中因摩擦而润滑各点。
三。纵切剪切加工设备在运行前， 彩涂板纵切还应注意检查控制阀、管道、刀口及其主轴是否磨损、开裂，螺栓是否松动，然后注意检查电路是否损坏，检查电器箱是否有异味或异常现象。
4最后要注意转台的点动操作和关闭。这时，还要注意检查刀刃和螺栓的紧固情况，然后压料。对于纵切机设备在选择连续或单次操作时，此时要按剪切开关进行剪切操作。

1. Before the operation of slitting shear plate cutting processing, we should pay attention to wear labor protection products, which include work clothes, safety helmet and related work shoes. Pay attention to check whether there are sundries on the equipment, and if so, clean it up. When the longitudinal shear processing equipment is in operation, its rotating part can not place any articles.

2. When the equipment is in use before cutting and processing, flammable and explosive materials can not be stored around it, which is in fact to do a good job in fire prevention measures; The next step is to check whether the oil level in the oil tank is normal and whether the oil quality is deteriorated. All lubrication points should be lubricated to avoid wear due to friction in actual use.
3. Before the operation of slitting shear cutting processing equipment, we should also pay attention to check whether the control valve, pipe, knife edge and its main shaft will be worn and cracked, and whether the bolts will be loose; Then, we must pay attention to check whether the electrical circuit will be damaged, and ensure whether the electrical box will have peculiar smell or abnormal phenomenon.
4. Finally, we should pay attention to the inching operation and closing of the turret. At this time, we should also pay attention to the checking of the knife edge and the bolt fastening, and then press the material. For the slitting machine equipment in the selection of continuous or single operation, this time to press the shear switch for shear operation.